JUMP TO:
Each tool has been designed to work with Epoxy-Tie cartridges for trouble-free dispensing. These tools are for use with SET, ET, and ETI Adhesives.
CDT10
Premium Manual Dispensing Tool for SETPAC-EZ and other Single Cartridge Adhesives
The CDT10 features a molded nylon reinforced body for ultimate strength and light weight. The handle is positioned under the cartridge for balance and ease of use. The drive mechanism is released by pushing forward on the drive handle. Cartridges “snap-lock” into position.
EDT22B
Manual Dispensing Tool for 22 oz. Cartridges
The EDT22B features a molded nylon reinforced body for ultimate strength and light weight. The handle is positioned under the cartridge for balance and ease of use. The drive mechanism is released by pushing forward on the drive handle. Cartridges “snap-lock” into position.
EDT22A Instructions (PDF, 100k)
EDT22CKT Tool (left)
EDT22CKT Charger (right)
Battery Powered Dispensing Tool for 22oz. Cartridges
The EDT22CKT offers power dispensing without the need for a hose or compressor. The tool features dosage and rate control for maximum efficiency. Each battery charge dispenses approximately 25 cartridges and recharging takes 1 hour. Tool comes complete with two 14.4V batteries and a charger.
EDT22AP
Pneumatic Dispensing Tool for 22 oz. Cartridges
The EDT22AP has an ergonomically designed nylon reinforced handle complete with flow rate adjustment. This lightweight tool (6 lbs.) also features a power piston return.
EDT22AP Parts Schematic (PDF, 431k)
EDT56AP
Pneumatic Dispensing Tool for 56 oz. Cartridges
The EDT56AP has an ergonomically designed nylon reinforced handle complete with flow rate adjustment. This lightweight tool (9 lbs.) also features a power piston return.
EDT56AP Parts Schematic (PDF, 426k)
- Air supply attachment is 1/4-18 NPT (male) thread.
- Recommended operating air pressure is between 80-100 psi (116 psi max.).
ADT813B
Manual Dispensing Tool for 8oz. and 13oz. Cartridges
The ADT813 features a molded nylon reinforced body for ultimate strength and light weight. The handle is positioned under the cartridge for balance and ease of use. The drive mechanism is released by pushing forward on the drive handle. Cartridges “snap-lock” into position.
ADT813 Instructions (PDF, 99k)
ADT30
Manual Dispensing Tool for 30oz. Cartridges
The ADT30 features a steel carriage and a molded nylon reinforced body for ultimate strength and light weight. The handle is positioned under the cartridge for balance and ease of use. The drive mechanism is released by pushing forward on the drive handle.
ADT30 Instructions (PDF, 96k)
ADT30CKT Tool (left)
ADT30CKT Charger (right)
Battery Powered Dispensing Tool for 30oz. Cartridges
The ADT30CKT offers power dispensing without the need for a hose or compressor. The tool features dosage and rate control for maximum efficiency. Each battery charge dispenses approximately 25 cartridges and recharging takes 1 hour. Tool comes complete with two 14.4V batteries and a charger.
ADT30P
Pneumatic Dispensing Tool for 30oz. Cartridges
The ADT30P has an ergonomically designed nylon reinforced handle complete with flow rate adjustment. This lightweight tool (6 lbs.) also features a power piston return.
ADT30P Parts Schematic (PDF, 432k)
- Air supply attachment is 1/4-18 NPT (male) thread.
- Recommended operating air pressure is between 80-100 psi (116 psi max.).
