Screens are used in hollow base material applications to contain adhesive around the anchor and prevent it from running into voids. Simpson screens are specifically designed to work with AT, SET and ET adhesives in order to precisely control the amount of adhesive that passes through the mesh. This results in thorough coating and bonding of the rod to the screen and base material. Order screens based upon rod diameter and adhesive type. The actual outside diameter of the screen is larger than the rod diameter.

Material:

• Acrylic-Tie screens: 50 mesh stainless steel;
• Epoxy-Tie screens: 60 mesh carbon steel.

Epoxy-Tie Screen
(Acrylic-Tie Screen Similar)

Screens are for use in hollow CMU, hollow brick and unreinforced masonry applications.

Contact Simpson for information on special order sizes.

Caution: Screens are designed for a specific adhesive type. Epoxy-Tie screens must be used with SET or ET formulations and Acrylic-Tie screens must be used with Acrylic-Tie. Do not use SET1.7KT or SET1.7KTA with screen tubes.

Acrylic-Tie (AT) Screens - Steel

Epoxy-Tie (SET & ET) Screens - Steel

Note: Not for use with SET1.7KT or SET1.7KTA.