• Drill a hole in the base material using the appropriate diameter carbide drill bit as specified in the table. Drill the hole to the specified embedment depth plus 1/8" for flush mounting. Blow the hole clean using compressed air. Overhead installations need not be blown clean.
• Insert anchor into hole. Tap with hammer until flush against surface.
• Using the Drop-in setting tool, drive expander plug towards the bottom of the anchor until shoulder of setting tool makes contact with the top of the anchor.

Caution: Oversized holes will make it difficult to set the anchor and will reduce the anchor's load capacity.

Installation Sequence
(Short Drop-In similar)

The anchor is fully expanded when the shoulder of the setting tool makes contact with the top of the anchor.