The Plastic Screw Anchor is an expanding plastic shield that expands as the screw is tightened. The PSA can be used in all types of base materials including concrete and gypsum drywall.
GALLERY: roll over images below to see larger image
PSA
PSAK06
MATERIAL
Polyethylene plastic
INSTALLATION
See below.
PSA Product Data
LINKS:
PSA Kit Product Data
INSTALLATION
Caution: Oversized holes will make it difficult to set the anchor and will impact the anchor's performance.
- Drill a hole in the base material using the appropriate diameter carbide drill bit as specified in the table. Drill the hole to the specified embedment depth plus 1/8". For flush mounting blow the hole clean with compressed air. Alternatively, drill the hole deep enough to accommodate embedment depth and dust from drilling. Overhead installations need not be blown clean.
- Insert anchor into hole. Tap with hammer until flush with surface of base material.
- Position fixture; insert screw and tighten.
Installation Sequence
