www.simpsonanchors.com


SLEEVE-ALL® Sleeve Anchors

Information on this page has been updated since the printing of the 2007 Anchor Systems Catalog (C-SAS-2007).
To view the specific changes made to this page in detail, visit Product Information Updates.

Sleeve-Alls are pre-assembled expanding sleeve anchors for use in all types of solid base materials. These anchors are available in acorn, hex, rod coupler, flat or round head styles for a wide range of applications.

MATERIAL

Carbon and stainless steel.

FINISH

Carbon Steel: Zinc plated.

INSTALLATION

For installation instructions, click here.

CODE REPORTS

  • Florida FL 5415.2 (PDF)
  • Factory Mutual 3017082, 3/8" - 5/8" hex nut
  • Underwriters Laboratories File Ex3605, 3/8"- 5/8" hex nut
  • Meets requirements of Federal Specifications A-A-1922A

The Load Tables list values based upon results from the most recent testing and may not reflect those in the current code reports. Where code jurisdictions apply, consult the current reports for applicable load values.

SUGGESTED SPECIFICATIONS

Sleeve Anchors shall be zinc plated studs having a minimum 50,000 psi tensile strength with an expansion sleeve meeting AISI 1008 cold rolled steel or type 304 stainless steel stud with a type 304 stainless steel expansion sleeve, as called for on the drawings. Sleeve anchors shall meet Federal Specifications A-A-1922A. Anchors shall be Sleeve-Alls from Simpson Strong-Tie, Pleasanton, CA. Anchors shall be installed following Simpson Strong-Tie's instructions for Sleeve-Alls.

 
 
Material Specifications
Sleeve-All material specs
 
Length Identification Head Marks on Sleeve-All Anchors (corresponds to length of anchor - inches).
Length Identification Head Marks on Sleeve-All Anchors (corresponds to length of anchor - inches).
 
go to top of page
Printed from
© 2008 Simpson Strong-Tie®