www.simpsonanchors.com


SURE WALL Drywall Anchors

Sure Wall anchors are self-drilling anchors for use in softer substrates like drywall. The point cuts a hole through the base material, eliminating break-out on the backside of softer base materials. The standard Sure Wall can be used as a fastener in fixtures with sufficiently large holes or a screw can be driven into the anchor body for smaller fixture holes or picture-hanging wire. The Sure Wall Toggle expands behind the base material for greater load capacity.

GALLERY: roll over images below to see larger image

Sure Wall Zinc

Sure Wall Nylon

Sure Wall Toggle


FEATURES

  • Self drilling: only a screwdriver needed for installation in gypsum board drywall
  • Standard Sure Wall: Can be used alone or with screws
  • Both designs maximize the load carrying capacity of low-strength base materials

MATERIAL

Standard Sure Wall: Die cast zinc or reinforced nylon;
Sure Wall Toggle: Die cast zinc

INSTALLATION

See below.

 
Sure Wall Standard and Toggle Product Data
Sure Wall Standard and Toggle Product Data
 
Sure Wall Kit Product Data
Sure Wall Kit Product Data

Kits sold in full carton quantities only.

Sure Wall Load Data
Sure Wall Load Data
Sure Wall Toggle Load Data
Sure Wall Toggle Load Data
 
INSTALLATION
go to top of page
 
Standard Sure Wall:
  • With the screwdriver inserted in the anchor, push the point of the anchor into the base material to get it started.
  • Screw the anchor into the base material, turning clockwise.
  • Hold the fixture in place and install the screw (screw is not needed when the fixture hole accepts the Sure Wall anchor).
Installation Sequence Sure Wall
install sequence
 
install sequence
 
 
Sure Wall Toggle:
  • With the screwdriver inserted in the anchor, screw the tip of anchor into the base material, turning clockwise.
  • Stop turning once the tip penetrates through the base material. Turn the anchor so that the arrow on the head of the anchor is pointing up and push the anchor until the head is flush with the surface of the base material.
  • Insert the screw into the anchor and push until the screw reaches the back of the anchor.
  • Begin turning the screw clockwise to engage the toggle and pull it snug against the backside of the base material.
Installation Sequence Sure Wall Toggle
install sequence
 
install sequence
 
install sequence
 
install sequence
 
 
go to top of page
Printed from
© 2010 Simpson Strong-Tie®