Sharing the same positive features as the larger Titen HD® screw anchor, the Titen HD Mini anchor provides an easy solution for jobs that call for smaller anchors. The self undercutting, non-expansion characteristics are ideal for situations where minimum edge distance and reduced spacing is a concern. The patented cutting teeth and thread design enable the Titen HD Mini anchor to be installed quickly and with less effort than many other screw type anchors. Since there are no secondary setting steps involved, the Titen HD Mini screw anchor can be installed much more quickly than traditional expansion anchors.
FEATURES
- Full length threads undercut the concrete and effectively transfer loads into the base material
- Specialized heat treating process creates high hardness at the tip to facilitate cutting while the body remains ductile
- Less spacing and edge distance required since the anchor does not exert expansion forces
- No special setting tools required, installs with regular or hammer drill, ANSI size bits and standard sockets
- Less installation time translates to lower installed cost
- Removable, ideal for temporary anchorage
MATERIAL
Carbon steel, heat treatedFINISH
Zinc platedINSTALLATION
- See below.
TEST CRITERIA
The Titen HD Mini anchor has been tested in accordance with ICC-ES’s Acceptance Criteria for Pre-Drilled Fasteners in Concrete or Masonry (AC106).
LINKS:
Titen HD Mini Anchor Product Data
Installation
Caution: Oversized holes in the base material will reduce or eliminate the mechanical interlock of the threads with base material and will reduce the anchor’s load capacity. Use a Titen HD Mini screw anchor one time only. Installing the anchor multiple times may result in excessive thread wear and reduce load capacity.- Drill a hole using the specified diameter carbide bit into the base material to a depth of at least 1/2" deeper than the required embedment depth.
- Blow the hole clean of dust and debris using compressed air. Overhead applications need not to be blown clean.
- Insert the anchor through the fixture and into the hole.
- Tighten the anchor with the appropriate size socket until the hex washer head contacts the fixture. Do not use impact wrenches to install into hollow CMU.
Installation Sequence
