www.simpsonanchors.com


Tested to Meet IBC2006
TITEN HD® ROD HANGER Masonry Threaded Rod Anchors

The Titen HD Rod Hanger is a high-strength screw anchor that provides a fast and convenient way to suspend threaded rod from concrete slabs and beams. The anchor’s high load capacity and ease of installation make it ideal for hanging pipes, equipment and fixtures in overhead applications. Unlike traditional drop-in anchors, installation requires no special tool or secondary setting process; just drill a hole and drive the anchor. The serrated cutting teeth and patented thread design enable the Titen HD Rod Hanger to be installed quickly and with significantly less effort when compared to other screw type anchors.

FEATURES

  • Compatible with 1/4", 3/8" and 1/2" diameter threaded rod
  • High load capacity as a result of the full length threads that undercut the concrete and effectively transfer load into the base material
  • Specialized heat treating process creates high hardness at the tip to facilitate cutting while the body remains ductile
  • No special installation tools required. Holes can be drilled with a rotary hammer or hammer drill with ANSI size bit. Anchors are installed with standard size sockets.
  • Less installation time translates to lower installed cost
  • 1/2" size was designed for optimum performance in cracked and uncracked concrete, an IBC 2006 requirement.

MATERIAL

Carbon steel, heat treated

FINISH

Zinc plated

INSTALLATION

CODES

  • Factory Mutual 3031136 (THD37218RH and THD50234RH)
  • ICC-ES pending (THD50234RH)

The load tables list values based upon results from the most recent testing and may not reflect those in current code reports. Where code jurisdictions apply, consult the current reports for applicable load values.

Titen HD Rod Coupler
U.S. Patent 5,674,035 & 6,623,228
 
Titen HD Rod Hanger Product Data

product data

 
Installation
go to top of page
caution!Caution: Oversized holes in the base material will reduce or eliminate the mechanical interlock of the threads with base material and will reduce the anchor’s load capacity. Use a Titen HD® Rod Hanger one time only. Installing the anchor multiple times may result in excessive thread wear and reduce load capacity

  • Drill a hole using the specified diameter carbide bit into the base material to a depth of at least 1/2" deeper than the required embedment.
  • Blow the hole clean of dust and debris using compressed air.
  • IMPORTANT: Install with an applied torque of 15 ft-lbs for the 1/4" and 3/8" size Titen HD rod hangers using a torque wrench, driver drill, hammer drill or cordless 1/4" impact driver with a maximum permitted torque rating of 100 ft-lb.
Installation Sequence
Installation Sequence

 
Printed from
© 2010 Simpson Strong-Tie®